Dynomotion

Group: DynoMotion Message: 5507 From: mrosenfield2 Date: 8/2/2012
Subject: canned mill cycles
Tom,
Does KFlop or KMotionCNC recognize any canned milling cycles?
I couldn't find any references to such in the manual
Thanks,
Michael Rosenfield
Group: DynoMotion Message: 5509 From: Tom Kerekes Date: 8/3/2012
Subject: Re: canned mill cycles
Hi Mike,
 
There are some.  These are described in the original Public domain EMC documentation that KMotionCNC is based on.
 
In the KMotionCNC On-Line Help follow the link under Other GCode Commands.
 
or see:
 
 
 
Regards
TK

Group: DynoMotion Message: 5518 From: mrosenfield2 Date: 8/6/2012
Subject: Re: canned mill cycles
OK, that makes sense - thanks!
Now I am getting a gcode error when I load a program. It is flagging the "/" character as an error. I thought this was block delete, and a legal charater?
I checked the setup file, and block delete is ON.
If I just delete the "/" from the gcode file, everything is fine.
Suggestions?
Michael

--- In DynoMotion@yahoogroups.com, Tom Kerekes <tk@...> wrote:
>
> Hi Mike,
>  
> There are some.  These are described in the original Public domain EMC documentation that KMotionCNC is based on.
>  
> In the KMotionCNC On-Line Help follow the link under Other GCode Commands.
>  
> or see:
>  
> http://www.dynomotion.com/Help/GCodeScreen/EMC_Handbook/node66.html
>  
> http://www.dynomotion.com/Help/GCodeScreen/EMC_Handbook/node45.html
>  
> Regards
> TK
>
> From: mrosenfield2 <mrosenfield@...>
> To: DynoMotion@yahoogroups.com
> Sent: Thursday, August 2, 2012 7:39 PM
> Subject: [DynoMotion] canned mill cycles
>
>
>  
> Tom,
> Does KFlop or KMotionCNC recognize any canned milling cycles?
> I couldn't find any references to such in the manual
> Thanks,
> Michael Rosenfield
>
Group: DynoMotion Message: 5520 From: Tom Kerekes Date: 8/6/2012
Subject: Re: canned mill cycles
Hi Mike,

Block delete is not currently supported by KMotionCNC.  We'll try to put it in the next release.

Regards
TK